each ring = one day · each arc = one hour
quiet hours
in between
busy hours
quiet hours
in between
busy hours
How it connects
Start
- Install the boards once. Open Boards, plug each ESP32 in by USB and install its part: Sensor box, Hub, Sculpture. Needs Chrome or Edge.
- Power the sensor box and the sculpture. They find the hub by themselves (no addresses to type). The servos need their own 5–6 V supply.
- Plug the hub into the computer and double-click
Weathering.command. This page opens and connects. Three dots in the top bar turn green: hub, sensor, sculpture. - Sound starts with it (SuperCollider). Without a sound card it plays a virtual panel; Touch knocks on it. With the contact mics and panel speakers, start
Weathering.command --sound-live. - Leave it. A reading arrives every 5 minutes and is saved at once. At 06:00 and 18:00 the data is read again from the start and the sculpture takes its new shape.
If something stops
- Page closed: readings keep being saved by the app. Open
http://127.0.0.1:8770again, or double-clickWeathering.command. - Computer off or crashed: double-click
Weathering.command. The show reopens where it was; a run that was missed happens at once. The sculpture kept its shape meanwhile, and the sensor box kept about a day of readings and sends them now. - For weeks unattended (Mac mini): System Settings → Energy → Start up automatically after a power failure; add
Weathering.commandto Login Items; turn off sleep.
No hardware yet? Click Connect → Demo: a pretend room and sculpture, as fast as you like. Everything above works the same.
Boards
Plug one ESP32 in by USB, then click Connect a board. Install its part, change its settings, test it. One board at a time.
Setting up boards needs Chrome or Edge on a computer.
The app is holding the hub's USB port. To set up the hub itself, click Connect → Disconnect first.
Install
Sensor box
read every
Sculpture servos
| servo | pin | min µs | max µs | closed at |
|---|
group
keep every board of one installation in the same group